
Alkali-Free Adhesive Series
Alkali-free laminating adhesive, core adhesive, and facing adhesive — eliminating caustic soda for safer, greener, and more cost-effective production.
Product Catalog
For domestic and imported automatic board lines and single-facers producing 3-, 5-, 7-, and 9-ply board. Replaces pure starch or starch-plus-additive systems. ECT gain over 10%, gel point ~5–6°C lower, dosage about 80% of ordinary pure starch glue.

Xuegong special glue for corrugated board (corrugator-line special adhesive) is used on domestic and imported automatic paperboard lines and single-facers to produce 3-, 5-, 7-, and 9-ply board, replacing pure starch glue and starch with various additives.
Hard film: after reinforcement treatment, film hardness is high; flat crush and edge crush of bonded board improve clearly. Edge crush rises by more than 10%, fully reaching or exceeding starch-plus-additive adhesives.
Excellent moisture resistance: after moisture-resistant treatment, film moisture resistance is clearly higher than pure starch and close to starch with water-resistant additives, more reliably meeting carton moisture needs in humid environments.
Low gelatinization point: gel point is about 5–6°C lower than common starch. At the same steam pressure and temperature, start-up speed can rise clearly while bonding stays firm.
Strong bonding: firm adhesion means lower dosage — only about 80% of ordinary pure starch glue. Clearly raises board strength and start-up speed, improves moisture resistance, and saves cost.
This page is the special starch glue for corrugated board. It is not the water-only complete corrugator powder, not the all-purpose alkali-free concentrate that still needs native starch, and not the instant-setting adhesive matched to a boiler-free line. Do not copy mix ratios across these grades. Edge-crush, dosage, and speed figures need a side-by-side trial; they are not unconditional guarantees.
| Appearance | White or slightly yellowish powder |
| Odor | No abnormal odor |
| Fineness (80 mesh) | ≥95.0% |
| Bond Strength (room temp) | ≥5.88×10² N/m |
| pH | 7±2 |
| Moisture | ≤14% |
| ECT Gain | Over 10% |
| Gel Point | ~5–6°C lower than common starch |
| Dosage | About 80% of ordinary pure starch glue |
| Packaging | 25 kg bags |
| Applications | Corrugators, single-facers; 3–9 ply board |
Mount and calibrate infrared moisture sensors on a corrugator. Check them against oven samples so steam, dust, and coatings do not fake a dry web.
Test liner, medium, and finished-board moisture before the stack ships. Use an oven check so handheld meters stay honest and warp is caught early.
Control adhesive penetration on recycled liners and mediums—manage porosity, viscosity, glue gap, and solids so pin adhesion holds without washboarding.
Set gelatinization, viscosity, open time, and pin adhesion targets so corrugated adhesive and industrial starch glue hold bond strength at 250+ m/min.

Alkali-free laminating adhesive, core adhesive, and facing adhesive — eliminating caustic soda for safer, greener, and more cost-effective production.

For domestic and imported automatic board lines producing 3-, 5-, and 7-ply board; replaces expensive additives. About 15% higher ECT, gel point ~4–6°C lower; use alone or blend with starch.

Room-temperature / low-temperature boiler-free corrugated board production line technology with flute-to-flute (peak-to-peak) board structure. Single facer speed up to 300+ m/min.
Contact our engineers for grade matching, process advice, and a tailored quotation for corrugated adhesives.
Send Inquiry