Xuegong core winding adhesive (also called paper tube glue or tube winding adhesive) is specially formulated for paper tubes and paper corner protectors. This industrial-strength adhesive suits various tube and protector production equipment, and can replace white latex, polyvinyl alcohol, and similar adhesives.
Core winding adhesive technology: Our paper tube winding glue uses modified starch chemistry optimized for spiral winding applications. When paper layers wind around a mandrel to form a tube core, the adhesive must bond instantly yet remain workable. Our formulation delivers both — fast initial tack for secure winding, and controlled cure time for production efficiency.
Fast initial tack: bonds in about 5–10 seconds during the core winding process; dries quickly, typically through in 10–30 minutes. This rapid bonding is critical for paper tube manufacturing where continuous winding speed determines throughput.
Higher strength: finished tubes and protectors deliver better hardness and strength than ordinary white latex/PVA bonds, with better film moisture resistance for humid storage and marine export packing. The cured adhesive film provides structural integrity to the wound paper tube core.
Strong value: improves hardness and strength while clearly cutting adhesive cost — among China's high-performance, cost-effective core winding adhesives for paper-tube and corner-protector production.
Export trials that add water only should use the alkali-free paper-tube grade: no caustic soda, and no caustic or borax sachets. The starch paper-tube grade that uses those sachets is a different procedure. Do not mix the two, and do not copy either procedure onto laminating glue, corrugator glue, or honeycomb glue.
Alkali-free paper-tube glue: take 25–30 kg of room-temperature water and add one full 25 kg bag of powder. Stir fast. Do not stop for the first 5 minutes. Continue for about 20–30 minutes until the mix is smooth and free of lumps, then check viscosity. If it has not formed a glue, extend the stirring. If the viscosity is high, add a little water and record the extra amount. When faster drying or higher line speed is required, start at the low-water end of the range, and still keep a coat the machine can lay evenly.
Charge full bags. Scale extra bags at the same powder-to-water ratio. On a one-tonne mixer, use whole-bag multiples and keep the batch inside the tank volume. Set coat weight from the actual tube or protector bond, and keep the coat even; too much or too little glue can leave a weak bond. Liquid glue may separate slightly if it stands; stir before use. Cold weather raises viscosity, so a little extra water may be needed; hot weather lowers it, so use slightly less water. Do not let the glue touch alkaline materials or alkaline containers.
Use the caustic starch paper-tube grade only when the plant has accepted caustic soda and borax. Disperse one full 25 kg bag in about 25 kg of water. Separately dissolve the caustic sachet and the borax sachet in about 3 kg of water, and avoid skin contact. Pour that solution slowly into the main glue while stirring for about 15 minutes. If the viscosity is high, add water, but keep total water at or below 30 kg. Do not add those sachets to the alkali-free grade.