Technical Guides
Understanding Corrugated Board Flute Profiles
Learn about flute profiles (A, B, C, E, F) and how to choose the right one.

Common Flute Profiles
A-Flute (4.8mm): Excellent cushioning, ideal for fragile products
B-Flute (3.0mm): Good crush resistance, better printing
C-Flute (4.0mm): Most common, balanced performance
E-Flute (1.5mm): Excellent printing surface for retail
F-Flute (0.8mm): Thinnest, for rigid boxes
More in Technical Guides
Honeycomb Facing Glue: Floor Mixing for the Two Routes
Mix honeycomb facing glue on one of two routes. Water only uses 25 kg of powder and 30–40 kg of water. Adding starch uses 25 kg and 40–60 kg, in two tanks. Do not use this sheet on core glue.
Honeycomb Lines: Heat, Press, and the Two Speed Windows
Honeycomb core making is about 10–200 m/min. Face laminating is about 4–30 m/min. Cold press and hot press both exist. A slow start can run with the heater off.
Honeycomb Glue Film and Dry Speed: Slow, Fast, Quick, or Instant
Honeycomb line glue can be specified with an elastic or a rigid film, and with dry speed from slow to instant. On water-only facing glue, less water dries faster. Do not go below 30 kg of water.